I was using my phone to play coin dozer, while it was plugged in to the wall to charge when it wented compeletly black, hit the power button thinking it had gone to sleep, won't start back up, unplugged it, and replugged, duel core graphic came up, goes to battery graphic says 0% then 5%, then shuts off, it was at full right before it crashed/died.
View 5 RepliesSo yesterday my phone's fingerprint scanner began acting up. It would think I was swiping my finger when, in reality, I wasn't and saying It couldn't identify my finger. After a couple restarts, the fingerprint scanner doesn't work at all.I decided to go the route of a factory reset through the android recovery mode and wiped the data. After this, I select reboot now and all I get is a black screen with the green status LED stuck on.
View 8 Replies View RelatedI just got my phone three days ago. It is rooted. I attempted downloading an app called beats audio installer. Everything looked like it installed correctly, but upon rebooting, my phone remains stuck on the motorola logo. I have tried forcing it to power off, but upon turning it back on, it stays stuck on the m logo. I have tried recovery mode, even wiped all my data off hoping to remove the corrupt file, (I have everything backed up). Nothing. I've already gone through the menus, to fastboot it, reboot it, or reset it. Anything I select results in the black screen with the motorola logo.
View 1 Replies View RelatedThis morning my phone said it needed to do an update. So I hit update. about a minute later the screen went black and the motorola symbol popped up in the middle...than in the upper left corner it says Failed to boot 2 starting RSD mode......It will not do anything. I have taken the battery out several times but nothing.
View 1 Replies View RelatedI tried to do the update from morphine website and when it supposedly finished it rebooted into a failed to boot screen and then turns off. So what do I do now can I fix it or get a new phone?
View 3 Replies View RelatedWhat do I do when my screen says failed to boot 1. I've been on new software for several months and have not dropped my phone.
View 1 Replies View RelatedI'm completely stock. Never unlocked any bootloaders or flash anything that messed with the system. I used the Motorola Update software to check for new update and install it. After a reboot, my phone displays the following message "Failed to boot 4" and I can't get the phone to get out of it. The only way I can turn the phone off is with a battery pull. I was on a stock 1.8.3 before this mess. What can I do? Is this a bug in the OTA update?
View 3 Replies View RelatedI recently got a Motorola Atrix from a friend who used it for 3 weeks and then upgraded to another phone.
When I got it, after doing a factory reset thing, things were fine. But a few hours later after starting up I started to get this message:
svf:105:1:2
Failed to boot 0x1000
Entering NVFlash Recovery Mode
It appears for 2 seconds and then it's gone. I can't seem to do a hard reset; holding any of the volume buttons with the power button to turn it on just gives me this same message.
First let me say that I have done a search and I have read the threads that are the exact same issue as mine. The difference is that I have no idea what to actually do about my phone. Background - when gingerbread pushed to my phone something went wrong (although it was plugged in at the time) and basically my phone reboot itself in the middle of the install. The phone no longer works. When this happened (a few months ago) I had to have a phone immediately as I was heading out of town for a few days and had to have a phone to be able to get in touch with my pregnant wife if need be.Needless to say this is now my "backup" phone that is 10x better than the current phone I am using and I would really like to get it fixed somehow.
I have tried RSD lite. I have tried the motorola software update program. I have tried using the factory cable that was sent in the box. I cannot get the phone to recognize via usb so I cannot move a software to the micro usb card.I cannot access any of the options for the "no os detected" screen that appears. Most of them say that the battery is too low to flash.
this is begining whit firmware update gingerbreadmy atrix show in the display svf :105.1:2 failed to boot 0x1000thats al in the display that i see
View 2 Replies View RelatedI like being able to connect my phone to my laptop and the Motohelper system is a bit clunky but gets the job done.But it isn't a daily thing that I do. It isn't even monthly. It's just occasional.So how can I stop the Motohelper software from loading every time I start my computer? Is there a way to just start it when I need it? Turn it off when I don't need it?
View 2 Replies View RelatedI let my phone's battery run out, after plugging it in the the charger for about two minutes, i turned it back on, and my phone has been stuck on the AT&T Rethink Possible boot screen. I have done a batter pull, and still nothing
View 2 Replies View RelatedToday I noticed that if I take photos using the camera shortly after the phone has booted they are not stored on either the internal storage or external SD card even though it looks like the photo was taken.
View 4 Replies View RelatedI was having wifi connectivity problems and my phone was really slow and the screen wasn't as responsive as it used to be. I restored the phone a couple times but I didn't help at all, i even went to AT&T but the guys couldn't help me much but they tried to. As I was searching I found the--Removed-- It gave a failed error and when trying to reboot, it gives and 0x1000 error.
View 1 Replies View RelatedMotorola Atrix
svf :105.1:2
Failed to boot 0x1000
After showing this error my phone switch off. Its happened when I try to update my phone to gingerbread.
As I said in another post, I just bough a MotoNav N565T. My GPS had died and I found this one on clearance for an absurdly low price.I like manuals. I'm one of three guys in the country that actually read the manual for anything. However, the manual for this device sucks. Half of it is dedicated to using the phone.Are there any good instructions for this device available or am I expected to just blunder my way around until I figure everythign out?
View 3 Replies View RelatedI've tried holding down the power and volume buttons while it's plugged into the USB, but nothing happens.
View 10 Replies View Relatedid like to buy one of those over 3000mah batteries for my atrix 2 , but where i live i can only find this batteries for the atrix 4g and im not sure if it works on the atrix 2.
View 7 Replies View RelatedMy Motorola Atrix or Computer has a Problem install the ADB Interface so there for my phone wont connect to my Computer.I have a windows 7 32-bit operating system.I have tried installing Drivers Manualy, tried using the PDAnet Solution, tried unistalling all USB Ports, tried applications to help.
View 1 Replies View RelatedWill the Lapdock (and other accessories for that matter) work for the new Atrix 2 coming? I've only used the Lapdock lightly and it will be a real shame if it and the other accessories I've purchased over the past year won't work with the 2nd gen Atrix.
View 2 Replies View RelatedI want to synchronise my Motorola Atrix directly with Outlook on my laptop.How do I do it? Purchasing some application s/w is OK as long ad it works.
View 8 Replies View RelatedI recently had to get a replacement Atrix through AT&T after my original one shattered. I had insurance and AT&T provided me a refurbished one through their insurance program. My question is, will I still be able to get all future updates on this phone or is there something I need to do?
View 1 Replies View RelatedI was under the impression that once lapdock battery died, that the lapdock would run off the Atrix battery, is this incorrect?
View 3 Replies View RelatedI did the Jelly Bean update on my two month old Atrix HD yesterday. Then my apps started closing on their own and then the homescreen started doing the same thing. Tried to do a FDR and I have the little android guy on my screen now with what looks like a rotating atom in his belly and a blue progress bar below him. Been like this for several hours now and I even tried calling the Motorola people and I'm still where I was. Can anyone offer a solution before I take it back to where I bought it from to see if they will even replace it? I did the holding down the volume buttons simultaneously and then the power button, got the motorola logo and then goes right back to this annoying little android guy with the rotating atom in his belly.
View 6 Replies View RelatedOther android devices have the ability to synch with picassa to view their online albums am I missing something or is this a big whoops not included on Moto's part.
View 5 Replies View Relatedmy corporate email went down due to a security issue so i uninstalled it and reloaded it; i now get notifications again. problem is, now all of my apps that used to show live feeds (Internet, cnn, gmail, calender, contacts and email) just went away. they did not just stop and show blank screens as they have done before; they are just plain gone from the screens; so it's not like i lost my 3g feed.
View 2 Replies View RelatedI have never rooted my phone nor have I flashed a custom ROM before. I have a 32 GB HTC One M9 from Verizon on stock Lollipop Android, and it has been working perfectly until this morning. I woke up to my M9 stuck in a bootloop. It would boot to the HTC logo, stay there for about 10 sec, then go black and constantly restart again (even as I type this). I can access the bootloader, but it seems none of the options work for me! I can't boot to recovery mode or even power off my phone. It just constantly boots again by itself.
View 3 Replies View RelatedAfter a normal morning of Xoom use the battery was low so I turned the Xoom off and plugged it in to charge. This afternoon I unplugged the charger and tried to turn the Xoom on. I get to the Red Circle M with DUAL CORE TECHNOLOGY on the screen but no further. I am unable to turn the Xoom off. If I press/hold the Power button and the Up volume key the unit shuts off and then turns back on.
View 3 Replies View RelatedThis is the second time this has happened. This morning my alarm did not go off because the phone shut itself off. Phone was fully charged last night. This morning phone was off and would not boot up until I pulled battery.
View 2 Replies View RelatedI'm unable to get my dx to boot. I've been "granted" a replacement, which is due to arrive Monday.Do the actively disable your phone when they do that?I am at a login screen, with 7:00 PM Thursday Jan 1 showing. A blue triangle next to the 1x symbol. ALso showed wireless net detected symbol. I cannot interact with the screen. But the sd card can mount in Windows. Also says No Service.Is this anything of interest to folks in troubleshooting DX issues? Or a clear indicator that they have disabled this phone? I have tried hard resetting this phone like 10 times now.
View 2 Replies View RelatedI've rooted my phone but can't seem to change the boot screens, the Motorola logo if fine with me but I hate the boost animation and want to replace it, none of the ways I've found so far work, how to do this on this model phone?
View 1 Replies View Related