LG :: Versa Fails When Placing Call / Test Screen Value Power Is TXOff
Jul 13, 2010
I have an LG Versa that always fails when atempting to dial a call. It says "Calling" and the number dialed for about 30 seconds then says "Call Failed!!! Try Again". Everything else on the phone works fine.This happened after the phone was partially bricked and then an emergency flash was performed with LGNPST Lab Level 1.2 and the vx9600.dll. The phone has since been completely reflashed on several occassion with versions 3 & 4 software by the carrier techs, some "super techs" & myself "standard tech" but problem persist.
I have noticed if you go into Programming Mode (##77647269600 call then 000000) under Field Test & Screen that the value "TxPower" is always "TXOff" even while call is being attemped, before it fails. (see attachment) No one has been able to determine how to get the TxPower On. LG says that someone must have changed a setting, but they refuse to provide the information on how it is accomplished. Lg insist that it must be sent in for service.The phone is out of warranty.
View 1 Replies
ADVERTISEMENT
Mar 11, 2011
I recently saw a new icon appear on my screen when placing a call that I've never noticed before. It's a rectangle in the upper right hand corner next to the volume icon that has 5 or 6 little tiny 'x's in a diagonal
View 3 Replies
View Related
Dec 21, 2012
When I place a call, as soon as I've dialled (or selected the number from the contact), the screen turns off, menaing htat I can't hang up or for instance use the num-pad.
View 4 Replies
View Related
Apr 30, 2012
my iphone 4s has just switched itself off and now has no power at all or at least fails to start up again! Prior to shutting down there was grey and black vertical lines running down the screen and as i swiped to unlock, it just shutdown. I have tried plugging in the charger (although it was at 60% battery) too see if i could switch it on again, but after only a short time the phone was really hot so have now unplugged.
View 2 Replies
View Related
Dec 9, 2011
Has anyone else noticed a crackling noise (like bad reception / interference) when placing calls? I want to say what I notice is when I'm getting the ring back while waiting for someone to pick up is the "only" time I hear it. The audio in calls seems to be ok. It's sounds like a weak signal or interference. As far as I know (though I use my phone more for data than voice).I haven't noticed anything horrible as far as reception/call audio in calls, aside from when calling my mom, but I think that's her (she's famous for leaning on the mic or mumbling and trailing off). I start to think I must be old (I'm not) and losing my hearing (I'm not) but then I just realize it's herI don't know if it's because usually when I make a call I just unlock the screen and make the call and it was trying to re-start any data sleeping modes and such or if it's something else...
View 3 Replies
View Related
Nov 7, 2014
Scanner is very finicky. Sometimes it works, sometimes it doesn't. Tried registering multiple ID's using the same finger. Tried safe mode. Diagnostic test fails (doesn't vibrate) during safe and normal mode.
I bought this phone because of the fingerprint sensor (lots of sensitive business info in the phone), so i'd love for it to work normally.
View 10 Replies
View Related
Mar 6, 2014
I have a HTC One (bought in Thailand). When I dial a number and press 'call', the loudspeaker sometimes turns on automatically by itself.
At first I thought maybe my ear/cheek was pressing against the screen but sometimes even if I dial a number with the phone flat on a table, it will do this.
View 23 Replies
View Related
Mar 3, 2014
In the last few days or so after updating to 4.4 I've noticed that the speakerphone comes on automatically when placing a call. This is incredibly annoying.
View 24 Replies
View Related
Apr 26, 2012
When I place or receive a call I do not hear anything. When I put it on Speaker mode it works fine.
Info:
iPhone 4
View 1 Replies
View Related
Oct 21, 2015
When I place a phone call, I hear a bleep or a connect noise before the ring. I did not have that with that my S4. There has to be away to stop it with the S6
View 1 Replies
View Related
Apr 18, 2012
I place my iphone 4s on the table, so does it bring any harms or any damages towards my iphone 4s glass screen (I provide my iphone 4s with a back case and place my iphone 4s nicely in a pocket cover) when I got up from a chair and accidentally hit the table??
View 1 Replies
View Related
Feb 10, 2011
i have an sonyerricson X10 . and my phone is fails to power up with a SD card. when ever i take the SD card out the power is on, as long as i keep the SD card there the power is off cant be be.
View 2 Replies
View Related
Jan 4, 2010
I just got my 9700 less than a week ago, then I woke up this morning to make a phone call. After the call, my phone just turned off, and since then, it's been trying to power on. The BlackBerry screen will show, along with the loading bar, but it'll only load about 1/4 of the way, then the screen flashes white, then turns off, and does the whole thing over again. It's been going on for about 45 mins now.
I've also done the battery/sim pull.
View 4 Replies
View Related
Mar 18, 2011
Call Log Fails after upgrade to 2.1.A.0.435.This is major issue and there is no feedback from Sony Ericsson.
[code]....
View 1 Replies
View Related
May 10, 2010
I was wondering if anyone knew how to set the Samsung Rugby's radio to 2G only mode? Does anyone know the code to a field test screen?
View 1 Replies
View Related
Apr 16, 2012
Whenever my signal goes away and comes back I can't make calls or send sms's. It only comes right after I take out my simcard and put it in another phone and then put it back in my bb until the signal goes away again. This is frustrating me.
View 1 Replies
View Related
Feb 15, 2010
Had the Bold for just over a year, using Telstra in Australia and OS 4.6.0.144. No Facebook, have googlemaps but I exit whenever I use and have removed most apps.
Three times now the phone for no reason has got that hot that even in a holster on my belt, I felt the heat. The unit get's that hot that it drains the entire battery life in approx 5 min. I remove the battery, let it cool completely and then replace. Telstra don't know what the issue is and as it hasn't happened when I take it back, they will not look at it. Using the THB full car kit, the unit generates a lot of heat slow charging in the car kit cradle and on a heavy day I will get 3-4 hours use before flat, or I have to turn it off and let it cool down.
I have to soft reboot the unit evry 2nd day to stop the black wheel of death and the amount of Call Failed has increased to an embarrassing level. I have reported all these to Telstra and they are investigating.
I have since spoken to another user on Telstra with a Bold and upon describing my problems, he recounted a similar problem with his unit. His Telstra rep informed him that there was a problem batch of Bold's in Australia 12-18 months ago that had a known problem. They replaced his free of charge and he has had no such issues since and a massive increase in battery life. I recounted this our corporate Telstra rep to no avail.
We have 17 Bold's in the fleet, of which 11 came at the same time. Of these 11, 7 have the problem as described as above. Is this a common problem and how do I get Telstra to address ?
View 4 Replies
View Related
Feb 8, 2012
how to test your TOUCH SCREEN work good and all points in screen should work in nokia generally.
View 3 Replies
View Related
Jan 19, 2013
My Droid Raxr HD Maxx has developed a very bad habit. Whenever I initiate a voice call, the microphone fails. The failure is exactly at the point of connection, which is to say that I can use the mic for voice dialing. Toggling the speaker button or adjusting the volume (which is set at high) remedies the problem, toggling the mute button does not. This occurs on outgoing calls only; incoming calls are normal.
View 4 Replies
View Related
Mar 15, 2012
I used the PC Suite to put data on the phone but now I can not find it. How to I do locate the file I put on?
View 6 Replies
View Related
Jul 13, 2014
I cant access any website on my rooted 4.4.4 nexus .. I keep getting this message (The WAPGW fails to query user information(PLAT return fails))
Even on the play store i get server error .. On fb i get internal server error.. All Apps cant connect to the internet
Only way i can go online is using opera mini or
If i switch on reduce data usage on chrome weirdly it works .. When i switch it off i get the same error
Resetted data on google servicces and services framework with no luck
Attached Thumbnails....
View 4 Replies
View Related
Aug 13, 2012
any suggestions what to do gratefully received have done the ususal, turn everything of and on, remove battery, all are charged ok but computer doesnt seem to recognise bb any more and cant connect
View 7 Replies
View Related
Sep 26, 2011
Please tell me if there is anything I can do about it. Suddenly, the red key in my Nokia X2 phone which is the power key and end call key, stopped working - just does not respond when I press it. It means I cannot turn off or turn on the phone
View 2 Replies
View Related
Oct 28, 2011
If you use the setting to have the power button end a phone call, how do you turn the screen back on if it goes black during a phone conversation without ending the call?
View 6 Replies
View Related
Oct 7, 2012
Before the 'ice cream' update came, if i wanted to place an app in the sub group of MY APPS, I only had to long hold the app icon in the ALL APPS, and select where I wanted to place it in subgrop. Since the new update, if I try to long hold an app in ALL APPS it places the icon on my home screen. I do not want it on my home screen. How do I now place an app into a sub group that I already have created?
View 7 Replies
View Related
Jan 20, 2012
I'm afraid I know the answer to this issue, but is there a quick-fix (or has anyone had this before) to the lights underneath the bottom right panel buttons (the "Back" and "End Call/Power Off" buttons) not working?The lights underneat the bottom left side are still working, but barely.
View 3 Replies
View Related
Sep 11, 2015
i have mkt 6572 samsung galaxy s5 copy wcdma phone.when making a call/answer call and go INTERNET , auto power off. i change battery ,but not solve this problem.
View 1 Replies
View Related
Feb 22, 2011
I got used to end calls quickly that way in Android 1.6 and it worked pretty well for me for several moths. I actually found it a very good idea, one of the best and most intuitive since I started to use it.ow I often do not end my calls properly and that cauese me a lot of trouble. Local SE customer support told me that it is a firmware matter and cannot be changed. Isn't there any HW buttons configurator or another way to configure the HW buttons on the phone?
View 1 Replies
View Related
Mar 9, 2010
On my Blackberry Curve 8330 I could listen to music via bluetooth, then place a call using the headset's voice-dial button. When the call ended the music would restart. But on my shiney new Storm2 9550, this doesn't work. After the call ends, the phone just stays at the dial screen. Any suggestion on what I could try?
View 6 Replies
View Related
Feb 8, 2012
the new screen unlock bar which has been released with the new 40.xx firmware is just a malfunction.The sensitifity is too high.If you wait till the animated bar is coming to the center, then touch it with the finger - and still it unlocks.I have so many problems with this new feature - the screen/key lock is unlocking so many times by itselfs..Does anybody else experiences these problems?
View 2 Replies
View Related
Oct 27, 2011
Every time I get a call in my car, I answer it with my bluetooth. But when I do that the screen lock is going in unlock mode. I don't want it to go in unlockmode because my phone is in my trousers.Can I change this in the settings?? If I take a call with a bluetoothdevice the screen-lock must stay on.
View 2 Replies
View Related