The back cover of the Droid 4 can fool you -- it looks like a typical slide-down-with-pressure-to-remove cover. But there's a trick. There's a small pinhole on the black panel at the top rear, where the camera lens and flash are located, just to the right of "HD 1080P." That's the lock. If you insert a pin or other small object into that hole, it releases the back cover and it slides right off.
View 13 Replies
I recently purchased the Droid Bionic approximately 2 weeks ago. I got one for my husband also. Recently, my phone has been randomly shutting off and the only way to turn it back on is to remove the battery. It has also happened when the phone is on and I am charging it. My husband's phone has not randomly shut off at any time. I have downloaded a few apps which include Accuweather, Go SMS pro and PicSpeed Wallpaper. I also inserted my micro SD card from my old phone into the new phone which I just removed to see if the phone will randomly shut down. I also do not have the pocket detector on.
View 5 Replies View RelatedThe battery cover is pretty hard to get open I find. Anyways i was using my thumbnail to open the battery cover and as it slipped open my thumb slipped with it as well. There is a little piece of metal that sits right above the micro sd card. It is long and skinny and can be resting upwards a bit.
View 6 Replies View RelatedNokia 1661: Simple question. The users guide says simply to slide the battery cover down. It doesn't say HOW to slide the battery cover down. It does'nt slide.
View 4 Replies View RelatedWhat is the best way to snap back cover in place? Whatever sequence I use it seems that one of the plastic latches doesn't engage.
View 3 Replies View RelatedHow do you replace the top cover on the blackberry bold 9700 without removing the entire casing? I've found utube vids on removing the bottom cover but not for the top.
View 4 Replies View Relatedthe one thing that bugs the crap out of me is that the hard grey back cover doesnt line up flush with the softer top black peice where the speakers and camera are. it came out of the box this way. its only on the right side though (if im looking at the screen). it is perfectly fine on the side where the camera and power button are and fine in the center.i know to some this may seem trivial especially if you dont have this issue but i feel like i paid A LOT for this device and should have the quality build that was intended by motorola and was expected by me. the consumer.is this something that i could send in to moto to get adjusted? am i better off trying to "fix" it myself? am i alone in this issue?
View 1 Replies View RelatedI cant seem to find a way of removing my facebook account as there is no option to do so, theres only the option to add one
View 15 Replies View RelatedUsing Dolphin Browser... Anyone Know How/If I Can Adjust Position Of a Cover Photo?
View 1 Replies View RelatedI recently got the Motorola Car Dock for my x2 and am having a problem where the phone claims to be continuing to charge after I've removed it from the dock. More recently the Car Dock app will exit after starting. On that issue I've checked and it is not on the auto end list and will remain on when it connects to the car's bluetooth system.
View 9 Replies View RelatedI just finished installing the update and everything seems great but is there any way to change the Google bar at the top of the home screen? I liked it when it was transparent and I would love to have it like that again or even just take it off.
View 24 Replies View RelatedAfter my last thread which pointed out I was just simply lookin in the wrong place I bet there is a pretty easy solution for this too, I just can't seem to find it.Currently when unlocking my phone, I have to do the slide to unlock, and then input my pattern to unlock. I want my phone so that when I only have to do the pattern.The security options on the phone allow for "None", "Pattern", "Password", and "Pin". It says nothing of the slide to unlock feature and I can not figure out how to turn the thing off.
View 5 Replies View RelatedI got a bumper but I like a bit more bulk in my phone (3g/s with incase was PERFECT). I would also prefer something to cover the back.
View 6 Replies View Related3710 How do I get the back cover off? I had it off once to put the battery in; now it appears to be stuck.I 'm trying to follow the pictorial instructions, but it is not budging.
View 4 Replies View RelatedWhen I turn on my Samsung Galaxy S5 a message comes up telling me to check the rear cover is sealed properly before use. I've checked it & it seems well sealed but the message still appears.
View 2 Replies View RelatedI've used all my force to push, but it simply wont give in. It's solid. I push in, and trying to slide it out.
View 1 Replies View Relatedwell iPhone 4 backs are extremely easy to take off, unlike previous iphones where you basically need to dissassemble the entire phone starting with the screen, and void warranty to get to the back, the iPhone 4 back comes off by just unscrewing the 2 bottom screws. also Its possible to replace the back cover without voiding warranty, or leaving any evidence it was ever replaced.
If iphone 4s had the capacity laser etched on the back, apple employees would just look at the back of the iPhone to see capacity to know what capacity iPhone they should replace it with (i have seen them do this). Even if they go into settings to check something else, there is still a chance they will not look or forget to look at the capacity in the about section.If the iPhone 4 had the capacity etched on the back cover, a person could have just replaced his 16GB iphone's back cover with a 32GB one bought off ebay or something, ask for a replacement for whatever reason, and there could have been a good chance the "genius" would just look at the back of the phone, see that it is a 32GB unit, and give a 32GB iPhone as a replacement.or they could have decided not to etch the capacity on the back for cosmetic reasons
The back cover does not stay, so the back of the phone is open all the time. I checked and saw the two small clips at the botom conners of the cover are broken.So where can I find a replacement of the cover?
View 2 Replies View RelatedI just sold my 3G a couple days ago and picked up a cheap 3GS. I love it so far. The only thing is, is that the back cover is all sratched up and has like 30 dimples on it. So I want to replace it for a new cover but I don't know where I can get it, I tried to search e-bay but all I found is phone cases that go on top of the cover that I want.
Can anyone post up links to where I can get one? It would nice if I could also get a new chrome bezel trim piece too because that's damaged too.
Recently I got a new 'refurbished' Bold 9780 from Vodafone, I wanted to use my holster that I got from the box (the official one) , and whenever I put my blackberry in its fine, but when I take it back out the back cover (battery cover) slips off with it. I'm not sure why this happens, I put it in the correct way and everything. Maybe my case is loose? But I've tested the back cover, its perfectly on and doesn't jiggle about.
View 4 Replies View RelatedThis is the second 710 that have the same issue. The back cover around power button is starting getting loose after a week or 2 of usage. If I push the area slightly with my finger, it makes light noise. It is fatal problem but very annoying.The reason might be the plastic cover is not strong enough to stick to the phone body.
View 4 Replies View RelatedWhen I searched around for iPhone cases, I couldn't find any that covered the buttons and the back of the phone. I also could not find any screen protectors. The only case was the Zagg stick-on case, and I don't really want that little shock protection. Does anyone know if there will be more cases by the 24th, when my iPhone is due?
View 4 Replies View RelatedI recently bought my blackberry the other day and it's been working great. However today I notices the back cover keeps making weird clicking noises whenever pressure is applied. Everytime I go to pick it up in my hand to text, the cover makes this noise. It appears to be due to a pocket of air between the cover and the battery but the noise is getting really annoying.
View 2 Replies View RelatedI have a new storm 2 for Verizon and the back cover scratches real easy. I wanted to know if anyone knew how to get rid the the scratches? I have a cover on it now but they happened right away.
View 11 Replies View RelatedWell long story short my blackberry storm died today and verizon is sending me a replacement, and was nice enough to send me a storm 2 as a replacement only bad news is, the storm 2 replacement does NOT come with a battery door.so my question is, does the blackberry storm battery door fit the storm 2? if not,
does anyone know any reliable websites where I can get a blackberry storm 2 battery door?
How can I install back Adobe Reader LE after removing?
View 6 Replies View RelatedIs there a way to have the keyboard backlight work the same as the sreen backlight?
View 3 Replies View RelatedMy n900 died, I mean it, its just dead.I'll start by saying I tried all this and no go ..URL...All I see is the nokia logo and.. well thats it.
can't do anything with it, if I remove the battery and put back the logo goes back on and again, thats it.When pluging it to a usb my pc makes a sound like something was connected but the flasher and NSU do not find anything even with the "u" key pressed down.
Nokia: 5140 => 6131 => E61i => E90 => N95 8GB' => E71 => E75 => N900
Can i change my red black x3 cover to blue silver cover?Is it available?
View 2 Replies View RelatedThe back button on my original Droid (from 11/2009) is non-responsive at any time.Other 3 butons work fine. Nothing new added recently. Software issue or is it hardware. Never realized how much I used the back button.
View 5 Replies View Relatedwhen is the GB coming BACK out????
View 5 Replies View Related
