I've searched and I know this is a common problem.I've seen some solutions, but none have worked for me. So I am basically here to further my knowledge.Like many others, I edited the filedb to unlock the internet settings and when I turned the phone off it came back on looping.
Has anyone found a solution to this that works?The phone connects to every program, but I can't do much with it since it turns off. I've put it in emergency download mode, but a lot of good that does since nothing will upload to it.I can't get QXDM to connect to it. I've gotten everything else to connect.Bitpim, QPST, LG Download, LGUpdate.
Whenever I go to a weather website like wunderground and check out the radar, it never loops when I hit the animate radar choice. It just shows the current still radar image. Why is this? My MotoHint was able to show looping radar. Any suggestions?
Yesterday my Nexus 5 turned itself off and since then i can't get it back on. (Still got enough battery left then). When I try to start my phone with the power button nothing happens, and also when I try it with different combinations in buttons it won't start. Now, when I try to charge my nexus everytime the google logo shows up and it shuts itself down, this happens over and over again... as long as the phone is plugged in (same with usb connection on pc).
When I Try to do it in bootloader it shows up one second and shut itself off again. The device is/was rooted, I have to say that I did an update and after that it was half rooted I guess I don't know but for three days there stood a new update, but i never did it...
While on Instagram my G3 screen suddenly went blue and proceeded to boot loop. I get to the LG logo and then a blue screen follows, then the phone turns off and reboots to do the same thing over again, refusing to start up
I have tried to re-flash the stock ROM but i'm not able to access download mode as the screen just returns to the blue screen and shuts off.
My phone keeps looping, powering up and powering down and continues the process. I do not want to restore my phone where it will cause my pictures and video to be lost.
As above, when my screen locks a video plays. This is whether charging or not. I cannot get it to stop playing this video. Also, when I try to set up a PIN for my phone. A padlock appears over the number pad. I have also tried then to set up a swipe lock. The number pad again gets blocked by a Padlock.
My iPhone 4S keeps crashing or looping on the screen when I have a missed call. If I try to get out of it pressing the back arrow on the top left corner or I press cancel or ok buttons it just goes back to the missed call screen and I have to reset the phone for it to be able to anything at all. I'm on Claro network in Peru on an iPhone 4S 16gb
Ran the OTA on a non rooted X and when it tries to reboot it dies as soon as the home screen comes up and reboots and repeats until I pull the battery.
Nexus 5 keeps restarting (looping from Google Logo - 4 color dots screen)... I flashed lollipop from Google Website the latest one last Nov 22 if im not mistaken everything works great except yesterday. constantly looping to google logo then the 4 colored dots loading screen then google logo. I tried to reset volume up down + power or volume down + power but no lock. cant flash again because it wont stay on to the fastboot screen will reboot after few secs...
Was running 4.0.1, did the www.jailbreakme.com stuff, and then rebooted my iPhone and all I get is the Apple Logo.This did not happen when I rebooted my 3GS, but I don't know what to do now. It was my first time jailbreaking.
after my own iphone 3g was bricked after updating to ios4.02, now my wife's is too. i ended up having to do the update (restore) from another computer. my wife's update has been through her own computer, not any of mine, so no common issues were possible - except that apple has obviously fooked up! this is after a bricked update to 3.2.1 on my ipad which still has Internet issues and wifi intermittent troubles. i'm getting weary with apple.
I attempted to root the phone and when i updated the rom it just sits at the htc hagic screen.I try to send over the recovery or any other rom thru hboot/fastboot and nothing is working. I have looked everywhere and cannot find any information. Has this happened to someone or does anyone know how to fix this?
iPhone 3GS, 32 GB, nearly full memory (only 0.58 GB free, although there was 3.6 GB of 'other' memory in the bar shown in iTunes).
Started the update from iOS 5.01 to iOS5.1, downloaded to phone OK, phone rebooted, now it's stopped at the point where the silver apple is shown with an empty progress bar.
The phone does show up in iTunes at this point, correct serial number / phone number, but shows the entire memory bar full with the yellow 'Other' memory category.
The phone won't finish booting, can't get to the user screens on the phone.
Today i upgraded my iphone 4s to 7.1.2 and it bricked up at the end. This has never happened to me before on any upgrades. Problem is i can not turn off the phone to restore it because the sleep/wake button does not work. I was using the assistive touch method to lock my phone. I tried restoring from backup in itunes but it says can not because it is locked with a passcode...
The update provided new sources and new wallpapers, but when you tried to apply a new wallpaper, it froze for a little bit. When my phone did the respring, the home screen came up, and was froze. I couldn't lock it, or click on any app. Then, the screen went blank.
It literally won't do anything. When I connect it to itunes, my phone will make a sound as if it just plugged in (I have different sounds on my UI). I let it sync, but it still does nothing.Any help here? I'm desperate at this point, and almost hoping that it will let me restore, even if that does make it 4.0.2.
So I didn't realize that in order to upgrade to 4.0 you actually had to have your phone registered with Apple and now I'm stuck with a "We're unable to complete your activation." My phone is completely useless, unless I can figure out a way to downgrade or pay the $99 for the developer account. Is there any way for me to downgrade?
My device got bricked from updating. Got stuck at "Connecting to boot ROM". Device died, does not respond to anything, device manager says to change settings in computer control panel, followed the steps. Connecting and reconnecting device doesnt do anything, battery pull doesnt do anything, device manager can wake up the phone.
Picked up an 8820 for $10. The screen was cracked and I replaced that and bought a new battery for it. Nothing happens when I insert wall or usb charger into the port. Computer doesn't see device when plugged into usb. JL_cmder and MFI Multiloader can't find the device. the 8820 hasn't gotten wet so I'm not sure.
I have a iphone 3gs and clicked to upgrade to io5. Went through the wipe the phone process but when it goes to restore an load up the io5 its says error messages at the end. Everytime i connect it goes through the same process.I have disconnected antivirus and firewall ans still error messages. I have even loaded itunes onto a brand new laptop and tried to update and nothing but error messages after it "verifies" install. I am not getting to the stage to restore my phones apps and contacts - its just not loading my phone back to factory setting - i dotn really want the io5 now but want it back to working state!This had been for 3 days now.
Info: iPhone 3GS (8GB), iOS 4.3.2, Updating to io5
So my iphone just happened to go into a coma yesterday evening and I tried to turn it back on. I looked down to the cable connector on the bottom to see if there was any water damage. No red indicator. few hours later, I read that if you hold down the opwer and home button at the same time, it will reboot. However, I've held the buttons for MORE than 30 seconds--up to 3 minutes. Not to long ago, I also read that you should plug in the iphone and hold the two buttons, commencing the restoration process thingy. Again, held it down for more than a minute. I even tried it on my aunt's laptop and it still won't work. Either I'm impatient (I listen to music alot so it's like a drug), the battery/hardware failed, or I'm just having back luck with technology.
i plugged the phone into update it and it got about half way thru and lost the usb connection and bricked the phone . ive tried hard reset and nothing . all i get is a red light and the vibrate when u push the on button .
I've brought my nokia c5-00 on 20th jan 2011.Today I was updating my phone to it's latest version, but the software update failed in mid showing error "connection lost with the device". And from that point phone dosen't starts. When i press the power button i.e the red button used to cut calls, it only vibrates a bit with no light on screen and switches itself off.I've tried everything to make it work like pressing the call, star and 3 button to hard reset it but it had no effect on it, my phone dosen't even starts for charging.Then after a failed long effort to restore my phone I decided to take it to the nokia care.I showed it to the nokia care representative and after examining the phone by pressing the power button she instantly asked me if it's a failed software update by pc. I said yes it's due to failed software update. Then she forwarded it to the technician to repair the phone.Now comes the shock.....The technician said that the software update is failed due to a [B]bend in PCB plate[/B] and he showed me the PCB. The bend in PCB is something like thisAnd here are the images of my phoneI want to know how can the PCB plate bend like this if there is not even a scratch on the phone. Nokia care technician had denied warranty due to the bend in the plate. Where lies my fault in this?I live in meerut and visited two nokia care centers1- Nokia care, baccha parkRemark- will charge 70% of the original price of the phone and will change the PCB plate.2- Nokia care, abu laneRemark- They said the phone can be fixed or cannot be fixed and will charge Rs 1500.
I went to update my 8350i and it came up error. I have restarted PC several times. Used different PC to reload. I have even tried wiping it using JL commander on both PCs and use Crackmem and nothing is working for me.....any advice?
I work for a Verizon premium retailer (aka indirect store). So of course we don't have all the resources/equipment that a corp store does, but we still try to solve issues to the best of our ability unlike many indirects.
I had a guy come in yesterday with what I believe to be a bricked Tour...basically was stuck on the white screen that said it needed to be taken "for repair." After some quick research here I concluded it was probably due to the 5.0 problems people have been having and I had a new one shipped out to him next day under warranty.
The problem is he aparently has tons of contacts, and of course like many people didn't use DM to do backups. Is there any way that those contacts could be accessed? We do have the same machine a corp store uses but I'm thinking that's not going to pull them...I didn't know if there was a way to restore a earlier OS with DM and keep the contacts. I'm guessing no, but figured I'd check the best source!
I Have A Verizon BlackBerry Tour And Right Now Its Bricked With Reload Software Error 552, I Have Read Where i can connect it to the PC and restore it, but the only problem is that it wont even connect to my pc,it isnt connected to desktop manager or the pc
So I was using VZ Navigator for a little road trip this weekend, and as I was using it I noticed my Tour getting very hot. I checked the temp and Meterberry said it was 114 degrees! So I turned off VZ Navigator but a few minutes later my phone restarted itself and now the only screen I can see is a white one saying: "Technical Issues Please Return to Place of Purchase for Repair". Took it to VZW and they told me I need to get one overnighted to me and there was nothing they could do. Oh and I tried Desktop Manager and it wont recognize my bb no matter what I did (even the version without media manager). So now I play the waiting game without my BB. Has anyone else run into this problem with their tour overheating?
I agreed to give my old 1st gen iPhone to a friend of mine (as I've been on a 3G right now). I went and pulled it out of the storage shed, plugged it in, and booted it up. It came up just fine, prompting me to insert a SIM card (I had the phone unlocked).
Before giving it to him, I decided to update to the latest OS (which I had done on my 3G the week prior). So I plug it in to my MacBook, download the latest 3.1.3 update for the original iPhone through iTunes, run it through the latest version of Pwnage to get an ipsw, put the iPhone in restore mode, and update from the .ipsw.
I received an error, and the iPhone seems to have been bricked.Now, when turned on, it goes straight to DFU mode (showing a cable and the iTunes logo).When I try to update, the iPhone reboots at the "preparing iPhone" stage, and then iTunes errors out with:
"The iPhone "iPhone" could not be restored. An unknown error occurred (1611)."I have tried this from my MacBook, Hackintosh (which errored out with (2006)?), and Windows 7 PC. The first machine I tried it on was the MacBook.
I just got my iphone 4 today, i waited in line...took it home jailbroke it, added some ringtones. Thats it. THEN- i went to settings>reset> erase iphone its started to turn off then back on HERES where it gets bad! the apple come up then weird lines come up at the top the apple goes away to a black screen. THATS IT! it never does anything else!
I tried to put it in DFU mood by holding home and sleep wake... does the same thing and DOESNT go into DFU!!what can i doo?! if i take it into the apple store will the replace it , or will they find out i jailbroke it ?
