I have added my laptop to HandsFree list in my phone. And as soon as I turn on bluetooth on phone, it autoconnects to HF gateway. I don't want this. Can I configure my phone or PC to not do so. I prefere to connect HF not sooner than I will connect manually from phone, I make a phone call, or I play an audio file on phone. As I noticed active HF service limits BT bandwith drastically.
View 2 RepliesI have a Sony Ericsson C905 phone and can not connect it to the PC via PC Suite! to mention that I am trying to connect via Bluetooth to activate Bluetooth option is disabled you help me?
View 2 Replies View RelatedMy K800i turns itself off every (est.) 10 seconds after I turn it on. I tried taking the mem.card off & changing the batt but it didn't solve the prob.I used the master reset(all setting) but it wasn't successful because at the midst of the procedure, it turned off.Now whenever I turn it on, it only says "please wait" (probably because of the reset I did) but it would not continue even if I wait for a couple of hours.I tried updating it with Update Service but it failed. I tried several times and same things happened.
View 3 Replies View RelatedI have a W980. But it is stuck now, I couldn't turn on it again. I have no idea about this. Does anyone tell me what's problem with my phone and how can I turn it on again?
View 1 Replies View Relatedyesterday, i changing the housing/fascia of my fully working c902 (used a tuturial on Internet) and everything went fine until i finally assembled everything and found out that it wasn't turning on... i've checked everything a thousand times, every connector and piece and all seems normal but i can't solve this problem. there isn't any signal when connect it to the power either. i just feel the battery getting warmer, nothing else (the battery should be fine since i tested with a backup battery which didn't work either).what could be the cause? please, i'm getting mad with this problem, your help will be very appreciated.
View 3 Replies View RelatedI have a Sony Ericsson Elm. I use it for both business and personal calls. I see I can set categories of contacts and set different ringtones. What I would like to do is, say, when on holiday/weekends set the phone so that I do not hear a ringtone for work related numbers. I would still like to receive the call (go to voicemail) but not be notified when the call is actually incoming.
View 1 Replies View RelatedMy SE C905 won't turn on! Even if I charge it only the red light near the charging port lights and not flashing.
View 10 Replies View RelatedThe Vivaz phone suddenly cannot auto rotate during viewing of pictures, videos or surfing internet.
View 1 Replies View RelatedMy phone problem is when i was updating software through the update software suddenly power gone and came then again tried to update,but the update installation failed after that when i tried to switch on the phone the red light coming but there is no display.please help me with this problem. There is no display so what should i do?
View 1 Replies View Relatedwhy does my vivaz pro auto connect to the wifi?
View 1 Replies View RelatedI have the Sony Ericsson Xperia X10. I have a ford Mondeo car which has a built in bluetooth. I can connect to the hands free but I have to manualy reconnect everytime I get into the car. I was wondering if there was anyway to get the X10 to connect automatically as all my previous phones used to.
View 2 Replies View RelatedI have a w950i it contains a inbuilt memory 4gb. Now I switch it on but it shows the loading bar and after some time automatically restarts. How to resolve this case? I update my phones software too. I think the memory is corrupt.
View 8 Replies View RelatedMy w595 turned itself off and is now turning on and off whenever I try to turn it on. The buttons light up and the phone vibrates every couple of seconds but cannot get past the logo screen. If I can get my phone to sync with my computer in 'phone mode' the repair setting in PC suite may fix this problem but I can only connect in 'Mass Storage' mode. Can I update the phone in any other way?
View 7 Replies View RelatedCan anyone help me with this prob? My phone wont turn on. I've tried it so many times to turn it on but still, it remains the same. Red light blinking. What does it means?
View 1 Replies View RelatedI have noticed on this on my Sony Ericsson Xperia ray mobile phone that it makes some kind of sound on the camera application . whenever I try to take the picture or while exiting the application or if I tab the photo that is just taken . it like the small click sound but it very irritating . I am afraid is this my phone or there are some having the same problem on their phone, whether it's a norm .
View 1 Replies View RelatedTo start a new thread might have been a bit too much. But what the heck. How do you do this? I know you use a patch to make it Clear Bass but how do you put in visualizations in a Cyber-Shot phone?
View 1 Replies View RelatedI have paired my bluetooth device to Galaxy S5. No issues. If I go into my settings and select bluetooth, I see my device list as the only "paired device"
EVERY morning, I have to go into my bluetooth settings and click the _only_ paired device to connect. When I do, it connects with no issues.
All I want the S5 to do is connect when it gets in range (in range since bluetooth is always on).
I doesn't do this by itself. Why? I do not have any issues pairing. It just doesn't auto connect.
I have a Blackberry 8520 with the latest software. My Bury CV 9040 also has the latest software. Everything works well except for auto connect to the CV 9040. I would like it to connect when I turn the ignition on which activates the CV 9040 but I have to push the auto connect button each time which is not the end of the world but an irritation!
View 4 Replies View RelatedI turned my phone off then on. In the process of it starting up it kept on turning on and off by itself. I had no chance to do anything before it wouldn't turn off again. The battery said it was full but everytime it turned back on I could see it was loosing life. I went to plug it in to charge but that wouldn't help as it wouldn't charge while it was turning on and off all the time. I tried to take the battery out. I have taken the memory card out. Now it has frozen with a white lit up screen.
View 1 Replies View RelatedMy K850i has brod (vibrates and blue ring & keypad only lightup - it repeats these). I upload /boot folder from backup, but problem same then I reflash main, fs, finalize with a2uploader, but problem still same. Phone not dropped, no sign of hardware fault.
firmware: r1fa035
So I just bought the S5 a few weeks ago and am having trouble pairing it to my Acura RDX. The previous two droids I had seemed to have no problem with this.
-The S5 is paired with the car, when an incoming call comes in the phone rings and so does the speakers in my car. I simply just hit the answer button on the steering wheel and it answers the call.
-The problem: So now I want to make a call and this is where the problem occurs. On my previous Droids I would just pull up the contact and click the phone dial button. After doing this the phone audio would automatically bump over to my car speakers as soon as the line started to ring.
-On the S5 I would go to a contacts name or dial a number and it never kicks over to the car speakers, I have to manually click the bluetooth icon in the corner of the screen every time. Its weird that it works fine for incoming calls, but when placing a call I have to select the bluetooth icon.
Is there an Auto connect bluetooth headset option? I hate having to always choose to send a phone call to my hands-free device. What's the point of a Bluetooth headset if I have to use the phone every time to connect to it?
Info:
iPhone 4S
I have a Droid 3 and the bluetooth headset I have does not autoconnect (paired but not connected). I have to do it manually. My Droid 1 would autoconnect just fine. I don't see any option to auto connect. I saw some mention somewhere that there might be a code issue and someone sent something to google. I did not know if there was a fix for this. This was going on before and after the update.
View 4 Replies View RelatedMy phone was working good. I tried to update the software using SE update service. When I press C and connected the cable the software checked connected phone and replied product can not be identified, remove the cable and reinsert the battery. I did so. But now phone is not working when I try to switch it on, the screen just blinks with a light but no text on the screen. I tried to flash the phone too but it is also not wokring XS++ shows something link this.
20:14:53| XS++ v3.1 (Darwin) Ready !
20:14:53| Executed on Microsoft Windows Vista
20:15:03|
20:15:03| Attempting to open the interface...
20:15:03|
20:15:03| TURN OFF PHONE!
20:15:03| Hold 'C' button on phone and connect phone NOW.
20:15:03| You have 30 seconds...
20:15:03|
20:15:03| Baseband ID: 8040
20:15:03| Protocol Version: 3.1
20:15:03|
20:15:03| Sending db2010_cid00_prodid_p3l.bin...
20:15:03| Applet ID: 061113 1250 ALUCXC125872_COMPACTPRODUCTION_ID_LOADER P3L
20:15:03| This is a PRODUCTION_ID loader
20:15:03| Activating GDFS...
20:15:03| Phone name detected!
20:15:03|
20:15:03| Profiling SEMC phone...
20:15:03| Platform: DB2010
20:15:03| OTP CID: 49
20:15:03| EROM CID: 49
20:15:03| EROM Color: Brown
20:15:03| IMEI: 35255701xxxxxx
20:15:03| Phone ID: K750
20:15:03| Region: APAC_1
20:15:03| CDA: CDA102337/101 R5A
20:15:03| Firmware Version: R1CA021
20:15:03| EROM: n/a
20:15:03| Ready for operation!
20:15:32| Custpack information
20:15:32| Custpack: APAC_1 (CDA102337/101) (K750)
20:15:33| Generic(non-branded) custpack: Yes
20:15:33| Allowed languages: en, id, ms, tl, vi, zs,
20:15:33|
20:15:35|
20:15:35| Sending db2010_cid49brown_flash_r5a.bin...
20:15:35| Applet ID: 060316 1339 104_DB2010_FLASHLOADER_R5A_CXC1326738
20:15:35| This is a FLASH loader
20:15:35| Now flashing firmware main...
20:15:37| Flashing c:usersfais@ldesktopk750_r1ca021_main_eu_1_cl_red49.mbn
20:15:37| Header type: BABE
20:15:37| 288 flashblocks
I got stuck here, nothing happens after this.
Ever since I bought my Aino the bluetooth set does not clip properly in the docking station.You have to hold it down for a proper connection. Everything is in tact, nothing is broken.Is there a trick to clicking it in place?
View 2 Replies View RelatedMy Aino`s Bluetooth Device Hang even i can`t Turn Off It and not able to connect with Phone
View 2 Replies View RelatedI recently lost my phone and a friend gave me their old w580i. Somehow I may have deleted the connectivity tab under the settings menu. I cannot find any way to access my bluetooth for this phone. I ran the software update service and this did not fix the problem.
View 3 Replies View Relatedi own a w395 walkman phone. when i starts a bluetooth it shows meessege "canceled" and bluetooth never gets start. it also creates a dump files in memorycard each of 16 mb in size.i repair it for three times from service centre, two times they changed the motherboard of it, but after 7-8 days the bluetooth not functioning.
View 3 Replies View RelatedI cannot connect my Sony Ericsson Elm with my bluetooth headset MW-600.
View 1 Replies View RelatedCan somebody tell me if it has MP3 support for a full song? I think it will take about 4 if that's correct? No memory card support though? Does it have Bluetooth?
View 1 Replies View RelatedI have just changed over from a Nokia 5800XM to a Sony Ericsson Vivaz (U5i). On my nokia when it was connected to a bluetooth headset it would playback all music through the headset. How do I set up my vivaz to play music over the bluetooth headset?
View 2 Replies View Related