I have noticed that sometimes my IP4 doesn't go dim or sleep mode. Screen just stays on.. Usually happens when I have my text messages open but after my last message screen stays lit..
View 4 RepliesI've been using my Torch for 6 months now, and it has been working fine with the Holster (its a flip case) Everytime I close, it will auto go to sleep mode. However, since last week, the phone doesn't go to sleep when I close the flip case. I think it doesnt detect the magnet anymore. I check the Holster and the magnet is still there. I use another magnet to run it over the Torch but the phone just doesn't go to sleep mode. I've pulled the battery out and even tried with other casing, it just doesn't work anymore.
View 1 Replies View RelatedI installed CM12 on my Nexus 5 two month ago and it works fine. But I have the problem that it doesn't react when I press the powerbutton to wake it up from deepsleep mode. Then I could only reboot it.
I changed the "network type" in the settings to "3G" because my provider only supports it and I thought it could solve my problem. But it also hangs up the phone anymore.... I adapted the settings of the phone in the following way:
- Installed "Apex Launcher" as the default one
- Installed Klear Kat CM12 as Theme
- Additional Apps are: Greenify and SD Maid
I just tried the following steps to fix the problem:
1 . Installed another Launcher instead of "Apex Launcher" ---> I had the problem anymore with the other Launcher
2. Installed Open Gapps "nano" instead of "micro" ---> it ran without any crashes of the phone for a period of time. But now I have the problem again....
3. I wiped "cache" and "dalvik cache" again in TWRP --> System was clean and ran for a while. But after a period of time the problam "came back"
When I'm at home in my Wifi I doesn't have any problems with the phone to wake it up from deepsleep. Lastly I installed CM13 and had done an Fullwipe before... But I've the problem anymore .... I've the feeling that the phone looses it's reception and then the Launcher hangs and can't get up of his own....
When I am on the home page of my iphone 4S, the phone will not go into sleepmode. I have already backed it up and restored. Still only will go into sleep mode manually.
View 6 Replies View RelatedIs there a sleep mode for the sounds on my phone?
Info:
iPhone 4S
It also goes on 3G when on stand by or sleep mode...why??
Info:
iPhone 4S
Ok, so this is probably the worst combination of things to occur. If you don't care about reading the story I'm looking for a way to put my phone into DFU mode without the sleep/wake button. If there is a way to do this please let me know - if you want to know why I need to do this, read below... Thanks.
Last week my sleep wake button mysteriously stopped working. For a time it would work with every 5th or 6th press, but now it doesn't work at all. So for the past week I've had to forgo the use of the sleep/wake button, which means that when I'm done using my phone I had to put it into my pocket and hope I didn't hit anything until it shut itself off.
It's been manageable, but I have dreaded the day that my iPhone froze or anything, because I have effectively no way to restart the the device. Turns out that day was this evening - it froze while I was in Gmail, and I was unable to do anything. Home button was non-responsive - basically the whole OS locked up. Now obviously if I had a working sleep/wake button I could have probably held down both that and the home screen and forced the iPhone to restart - clearly I don't have that option in this case...
Worse yet, I decided to try to fix my sleep/wake button, so I took my phone apart. I wasn't able to really figure out what was going on with the sleep/wake button, and while I had the case cracked open it died. Once I got everything plugged in again, the phone turned back on, and sat at the Apple logo screen for a long time, after which it superimposed a spinning wheel over top of the logo. Truth be told, I don't think that disconnecting the screen had anything to do with the spinning wheel, I think it's a result of the OS completely locking up (the likes of which I've never seen the iPhone do before... so something in the OS must have become corrupted... at least that's my theory anyway).
It has been/continues to be stuck in this loop. I'm not sure whether letting the device die and naturally resetting itself will do the trick. I'm leaning towards the idea that it probably won't help the situation. I have not yet tried to do a restore, because I'm worried that it won't work, and then I'll lose my backup as well.
So yah... does anyone know how to force the iPhone into DFU mode without the sleep/wake button?
When in sleep mode iPhone 4 loses signal but when it's back on it searches and finds signal. iOS was 5.0.1, update to 5.1 but no changes.
Info:
iPad, iOS 5.1
I can connect to my home wifi fine and it has great signal but the phone keeps disconnecting when it sleeps and never reconnects. The wifi network has a password and everytime it makes me enter it. is there away it can remember this password so that it automatically connects? and is there a way to stop it disconnecting maybe an app?
Info:
iPhone 4S, iOS 5.1
Iphone works so good till it goes to Sleep Mode or till i will press Power button...it just freezing.. black display.. and nothing help.. only Hard reset.. It started after updating to 5.1.1. I` ve tried to update again-doesn`t help.. restart-also doesn`t help..
Info:
iPhone 4, iOS 5.1.1
The button will not respond, no matter how long/short I hold it down. It's like it's not "popping" back up, or gives anyresponse. I upgraded it to IOS5 last week, had no problems, until yesterday when it for no reason wouldn't act the way it should..
Info:
iPhone 4
My Iphone sleep /shut off button doesn't work.
Info:
iPhone 4S, iOS 5.1.1
my sleep/wake button doesnt work anymore. is it still under warranty if its not a year old?
Info:
iPhone 4
Few weeks ago we bought 2 iPhones. One them has solid click sound when you press the buttons, the other one is nearly silent. Which is the normal?
Info:
iPhone 6, iOS 8.1.2
Since last week my date & time have not worked on my 5c. The date & time are constantly wrong. I've shut down, doesn't work. Set it automatically, doesn't work. I don't get texts or calls when it's sleeping.
Info:
iPhone 5c, iOS 7.1.2, can't update iOS bc not enough space
Recently updated my iPhone 4 to ios 7.1.2. Currently my worst problem: instead of going into sleep mode, the phone turns off completely. I then cannot turn the phone back on with the sleep/wake button. To turn the phone back on, I need to do a hard reboot each time by holding down the home and sleep/wake buttons simultaneously. I have tried going into settings/general/reset and selecting "reset all".
Info:
iPhone 4, iOS 7.0.2
Since the whole 2.0 update, I have been having problems when it comes to getting my Playbook out of sleep mode. When I swipe the screen to wake it up, the backlight comes on, and a bunch of grey lines are displayed. The same thing happens if I use the power button to wake it up. Sometimes it will display everything but will be a negative (what should be dark is light and visa versa). I either have to reboot the playbook, or keep putting it back to sleep and waking it up over and over again until it finally works.
View 1 Replies View RelatedWhat's the difference and if I have both on does it cancel out the other? I had both on before and my phone never turned off the data connection.
View 3 Replies View RelatedI bought yesterday a Nokia X2-00 and been exploring it for a while, so far so good, pretty happy and satisfied with it, but there's a problem that bothers and I can't seem to find a solution for it. About the screen-saver, I can, for example, put it as a digital clock, and set a timer for when the phone to switch to screen-saver mode. Problem is, I don't seem to find anywhere an option to play with the sleep mode - no matter what, about 10 seconds after the screen saver goes active, the screen goes totally black (goes into sleep mode) and I need to press a button to wake it up. No digital clock display, no nothing.I need to be able to see the clock (and possibly an icon for missed calls/new texts) without having to touch a button. On all my old phones you could play with both screen saver/power saving/sleep mode options, but not here. What can I do?
View 5 Replies View RelatedWhy after updating my device my battery is draining even in SLEEP mode?
View 21 Replies View RelatedI have a strange symbol in my status bar (see attachment). I am having problems that the phone won't enter sleep mode..perhaps this could be an issue.
View 10 Replies View RelatedMy Wi-Fi always turns itself on when the phone is 'asleep'. Here is a screenshot of my Wi-Fi settings. I can't figure out how to not make it turn on like that.
View 2 Replies View RelatedI have a samsung galaxy s6, and the battery is draining rapidly because for one, the light will not stay off on the home screen, it keeps coming back on and off. this is my second phone now in two months.
View 3 Replies View RelatedI got my Milestone up on Bell's network and configured it all day. Lot's of notifications of email, SMS etc. Now I want to sleep, but need the phone to still ring and SMS to notify me, as I need those for work. Any way I can selectively mute some notifications and not others depending on what time it is? I couldn't find any apps that did this, but there's quite a few.
View 1 Replies View RelatedI've gone through a couple phones now, but I am still having this problem with the Triumph. Periodically, when the phone goes into sleep mode, it will not come out when pressing the power button. I have to take the battery out and replace it to get it to function correctly again. After experimenting with it a bit, it seems to only occur when I have Wifi enabled. When Wifi is off the phone seems to function in and out of sleep mode correctly. Anyone else experience this and/or have a fix for it(beside keeping Wifi disabled)?
I have also experienced some of the same issues that others have addressed on this site (random rebooting, slow GPS), but my Wifi sleep mode problem gives me the biggest headache.
My phone had an 80% charge last night and the nightime battery extender mode was on (as it is every night). Five hours later I woke to the flashing green light so I tried to check my messages. The screen would not come on. I knew the phone hadn't powered off because of the green light. I called from my home phone but there was no sound either. I looked online and found how to force a reboot (power on and volume down button at same time). The phone came on and said it still had a 50% charge. It did NOT show my missed calls! I called Verizon and they tried to say it was a fluke thing and not to worry. This has never happened before and the phone is only a month old. I rely on the phone as an alarm so this is especially disturbing, as well as the unknown missed calls.
View 7 Replies View RelatedI have tried lightly pressing the power button to get this puppy to sleep, but the battery runs down anyway. So, maybe I'm doing something wrong. How do you get the xoom to sleep?
View 15 Replies View RelatedI see how to keep my PC (XP) from going into sleep-mode, so Zumocast can access files. It would be cool if, PC didn't have to stay awake 24-7so as to save power, noise, PC fan life. Can Zumocast do that? My Squeezebox server has the capability for the remote device to wake it.
View 1 Replies View RelatedBluetooth ear bud will not work once sc. Have tried unpairing, turning off device, and rebooting.
View 1 Replies View RelatedJust a quick question; which is better for saving battery when my Blackberry is sat in my pocket - Keyboard Lock or Sleep Mode? I don't use the holster. Also, what are the main apps that kill battery on the BB and any tips to save battery?
View 11 Replies View RelatedSince updating to 5.0.0.484 on my Sprint 9630, my individual ringtones for SMS aren't working anymore. Also the top right button to put my phone in "sleep" mode, to concerve battery doesn't work either. Any help? Or ideas to solve this.
View 5 Replies View Related