i installed cm9 through x rec from my sdCard on my w8...... n since then my phone doesnt boot..... it only shows the white bold lettered SE logo, which desappears n the screen stays on with no display....Doesnt even go into CWM or xRec by pressing the back button continuously.....
View 1 Replies
I need help desperately.my Sonyericsson w580i is not powered on. I lost my power button few days ago and I opened my back panel and tried to power on by using tooth stick by pressing small button. Somehow I broke that one too.Is there any other way to power on my device for few minutes only, I need to copy all contacts from phone to sim.
View 4 Replies View RelatedMy K810i can't startup. Battery is fully charged. When I press power button, just have flash at IR receiver.
View 10 Replies View RelatedMy phone problem is when i was updating software through the update software suddenly power gone and came then again tried to update,but the update installation failed after that when i tried to switch on the phone the red light coming but there is no display.please help me with this problem. There is no display so what should i do?
View 1 Replies View RelatedI am trying to control few SE mobile models such as W595, W705 and more in remote via serial module (Hyper Terminal and others). After a period of time where things went smoothly I ran into 2 major problems:
1. Only the first device is installed correctly on the pictures. All other devices identified as "Other devices” and it takes a lot of time (more than 10 minute) till the second device driver are installed.
2. When I run an automation test which communicate with the SE device via serial (using the comport identified in the device manager as management) suddenly the device stops response to the serial commands from any serial tool (my application, Hyper Terminal, etc). What I see is that the device remain identified in the device manager but doesn't response. When I close the serial session and reopen it I get the response of the previous command.
Like the subject says, I'd like to know if others are experiencing a slow response / lag when you start entering a new message. On my Satio, the letters start showing up real slow then all of a sudden it catches up. Real pain. Others seeing this on your Satio ?
View 1 Replies View RelatedI've finished downloading the software update for my vivaz and now im trying 2 install it but it keeps dropping out any idea on how to fix this so it wont continuously drop out
View 2 Replies View RelatedAs I keep receiving "certificate expired" message after each installation attempt, and All after installation of latest firmware, Can someone tell me what to do?
View 1 Replies View RelatedMy girlfriends SE K550i died yesterday. If you try to start it it flashes red a couple of times then nothing happens. I have read about this and I thought I could reflash the phone to see if that fixes it. I have tried with XS++ and when I press 2 and 5 and connect the phone the program reacts but it stops at "Protocol Version 3.1" then nothing happens. The phone doesn't react when I put it in the charger so perhaps the battery is all drained too.
View 2 Replies View RelatedHow to delete installation files from handphone memory?
View 4 Replies View RelatedI am using "Sony Ericsson Vivaz". First time I had install some "sys" files and "jar" files, but now can't install sys files, now installing jar files and java files only, getting tow type error messages, if the mobile date is correct "certificate expired". When I am changing time to back certificate may not yet be valid, is expired or the phone date set may be incorrect". I am already done formating phone, memory card and updating.
View 1 Replies View RelatedToday, while i was recharing my Sony Xperia Neo V using the USB Cable connected to my desktop, i have received a call for which i have disconnected the phone from charing and attended the call.
After my call, have observed my phone restarting automatically. From that time, my mobile was very hot. It is hot at receiver location. Which is at the top of the phone. I have dismanteled the phone, expecting it would be fine after some time, but it remained hot for around 1 hour. Finally i have removed battery from the case and kept it open.
After 30 min, mobile is in normal condition and i again switched on the mobile. 75% of the battery fell to 1 % in hardly 5 min. I connected the USB again to recharge the mobile, but the battery was charged to at most 4 % , but mobile got heated up again. I decided to remove the battery and switched off the phone for around 5 hours.Later when i tried starting the phone, it was not starting, not charging. Tried multiple times,but not charing, when ever i connect to charge, phone is becoming really hot.
Just reinstalled the software on my phone and now it refuses to start. Screen lights up and computer beeps but no nokia screen.
View 1 Replies View RelatedJust reinstalled the software on my phone and now it refuses to start. Screen lights up and computer beeps but no nokia screen.
View 2 Replies View RelatedI'm trying to download a new software update for my W760a, because it tells me it cannot add anymore contacts and I can't recieve or send texts/ phone calls. When I try to go to the software updates on the W760a hompepage, it loads a blank page. It just says on the tab "Sony Ericsson Support Phones Topic Updateserviceapplication W760a", and loads a blank page. Please help me with this problem as I wish to continue using my new phone.
View 1 Replies View RelatedI thought I may start an Elm/Hazel thread for discussion as it seems many of you have one of the two phones now. I wanted to do this to discuss any problems with things like firmware & issues & other stuff rather than discussing this in the picture thread. Esato Awards King of Garbage 2009/2010 & Best Debater 2009 x10 & Nokia N8
View 1 Replies View RelatedI think the fone fell, cause it was dusty or maybe its because it was charged using the USB cable. What can be the possible cause of the phone not to turn ON?
View 2 Replies View RelatedAs the title implies, I need to ask if there are varying kinds of Sony Ericsson LCD screens for the G705 or if there are variations in models made. Nearly 6 months ago I bought a Sony Ericsson G705 phone off eBay that only needed a new LCD screen. Well I purchased a screen off eBaand was good to go except for a few minor issues...
1.) The LCD screen had a thicker screen/border than the original so I had to mod it by taking off the white border around it.
2.) The ribbon that connects the LCD screen to the G705's keypad wasn't aligned correctly causing it to disconnect from the keypad every so often. This too I had to fix by sticking some paper underneath where the connector sits. It worked after the modifications but the end result is the keypad was raised causing issues where pushing the up key would force it to push the left key too. Unfortunately after awhile the screen stopped working likely due to the fact the different layers were separating. I gave in and bought a new screen from an online dealer elsewhere just to get scammed in the end with a broken LCD screen which they refused to replace claiming I cracked it. So now I've purchased a new screen of eBay yet this one has issues too, it's thinner than the first one I got, but has the same problem where the ribbon doesn't appear to be aligned correctly either. This time however, I get some ugly dead pixels in the lower left corner of the screen and the rest is completely jumbled with white lines going through it. I've already contacted the seller for an exchange and am about to lose all hope getting this phone working. Anyway, back to the topic. Do the screens in the G705 vary from region to region or between versions? When I got it I found the phone was from Hong Kong (firmware was HK anyway.) though the manual and included paperwork suggested it was from France. The screens I have purchased seemed to have varying differences between either the thickness is too wide, the ribbon doesn't fit the correct position, or some other incompatibility. I bought this phone.
I've followed the correct configuration settings for my mobile operator in the Philippines which is Globe Telecom. Still I can't connect. There is no signal indicator appearing on the upper part of the screen like 3G/HSDPA/EDGE/GPRS. Just plain signal bars. Is that ok? Is the signal means GSM only and no Data signal?
But when I tried to used other mobile operator like Smart Telecom, it perfectly worked.
Right, well I've had the phone for just over 1 month now and the other day it ran out of battery. When I went to charge it, it wouldn't start charging!I've tried charging using usb and PC.. still nothing... The red light just flashes slowly but never does anything!
View 9 Replies View RelatedDoes the Xperia Neo V box come with Sony Ericsson earphones?
View 9 Replies View RelatedHow can I sync the calender and contact in my at&t C905a to the new at&t Xperia X10? On AT&T's site,it says to use PC Suite,which I already have in my notebook pc to back up and sync with Outlook in my pc. Is this true? And why can't I sync using SE Sync? Is it because the phone (C905a) is locked out?
View 2 Replies View RelatedI have been trying to synchronise my Xperia X8 to the Sony Ericsson website. It worked the first time when I set up the sync, and managed to copy over my calendar. However, my contacts weren't backed up on the website, so I tried again to synchronise my phone via the sync 'app' on my phone (as before) to copy them over, too, but a message kept popping up in the status bar of my phone saying 'No network access. Please try again later.' My network coverage is '3 out of 4 bars', according to my phone, so it should be quite strong. I have been trying repeatedly to sync over at least 3 hours, but with no success, and the same message keeps popping up, regardless of the fact that my phone shows a good network coverage.
View 1 Replies View RelatedSo my Xperia X8 is stuck on the Sony Ericsson logo, and Update Service doesn't recognize it even though I perform the on-screen instructions.
View 3 Replies View RelatedAnybody here tried to play music through the Sony Ericsson MBS 100?
View 1 Replies View RelatedMy phone looks like a tiny brick now. I can't reset it, I can't upgrade/fix/repair because it's stuck at the SE logo. It happened after internet browsing I've been prompted to forcefully close the browser, then later on it wants me to close the SE home app, then finally it's reset and I can only see until the SE logo.
I tried removing the battery for more than 10 secs, pluggin the usb cable while pressing back - still can't connect to pc. I tried holding down power+home, nothing.
Is there a hard reset button somewhere I can use? I'd rather reset everything with all my data than send it over to SE support since that means it'll take weeks with no phone
Just upgraded to 2.1 . However , i lost majority of my contacts . For example , in messaging , it only displays their numbers and it does not show up in contacts list . I have all my contacts in SE sync however i cannot log in . When i try to log in into SE sync from phone , after typing username and password and pressing ( touching ) log in , nothing happens .
View 9 Replies View Relatedi am waiting for the ICS 4.0.4 update for my xperia neo. my SI no. is not in the list yet. but i wanna ask this question. is it possible for me to upgrade to ICS 4.0.4 by first downgrading to the factory default 2.3.1?? the reason im asking this is that ever since i upgraded from 2.3.1 to 2.3.4 i have been getting this O2 operator start-up n shutdown screens on my phone as well as apps like O2 priority moments which i just cant delete. my phone is not network branded in ANY WAY. i dont even use O2 service. i tried uninstalling and reinstalling the 2.3.4 update several times, but the O2 thing never goes off. but wenever i did a factory reset n revert back to the factory default 2.3.1, the phone is fine with no signs of O2. so plz clarify on this. is it ok to downgrade n then upgrade to ICS?
View 6 Replies View RelatedI have just spent ages typing all my contacts on the Sony Ericsson website. I then connected my phone and did the sync. All appeared to go well... appeared. The problem is is that all contact names were transferred, but very little of the actual contact details. Only one phone number or an email address, but never a street address, birthday etc etc. I don't have an sd card. Could that be it? Just the most basic information has been transferred. I have no idea what I'm doing wrong/what step I've missed.
View 8 Replies View RelatedI cannot sync my contacts from my phone to my pc. I have faithfully followed the instruction, but it goes no further than the Import page. It asks me to look for a VCard file, but all I could see was a contacts.csv fle which I thought was the one, but it said "Could not export" or something to that effect. I know the synch works otherwise because I have been able to change my bookmarks online.
View 4 Replies View RelatedI can't add my Sony Ericsson account to my X10 mini pro. When I go to the Sync tab, I press the button for add a new account, then I select Sony Ericsson, I enter my username and password (I checked that the're correct by logging In via web on mi Desktop computer), but when I try to access nothing happens.
View 1 Replies View Related
