BB Bold 9700 :: Bold 9700 Changes Keyboard Color

I found it out! You have to dismantle the phone, though. Walkthrough:

1) Remove the bottom plate with the branding (use guitar pick, small flat screwdriver, etc)
2) Remove and save warranty sticker in case the phone actually breaks.
3) Remove the two small screws on either side of the phone.
4) Using a guitar pick, small screwdriver, or case-opener tool, start on the sides of the phones slightly below the convenience keys and move down towards the bottom. On the bottom, there are three small clips that WILL NOT BREAK NO MATTER WHAT. Disconnect them. Then remove the keypad top first.
5) Slowly slide the pick/driver/tool from the bottom edges of the phone up until the volume rocker. One tab on each side should pop, but they are difficult. Take your time.
6) Grip the sides of the bezel and slide upwards. The top cover should come off along with the back chrome bezel (the one above the camera).
7) The phone will now appear very basic with only the trackpad and screen recognizable. On the white lower portion, several small, rectangular LEDs can be seen.
8) Use a preferred color of sharpie to color a large clear piece of packing or scotch tape, and cut it into 2mmx2mm squares.
9) Place one color square over each LED. Reassembly
10) Insert the keypad into the bezel bottom first, making sure that the screw tabs for the keypad are underneath the screw tabs in the bezel.
11) Holding this configuration, slide the bezel on top first.
12) Make sure the hole for the trackpad and the trackpad itself line up, this will assure you that the keypad is in right. Also look at the "frets" in the keypad.
13) Push on the bottom of the bezel until you hear at most three clicks (the three tabs locking back into place)
14) Run your fingers along the side with pressure to make sure that you snap in the single tab on both sides of the phone.
15) Insert and screw in the two small screws you took out before.
16 OPTIONAL) Put back the warranty sticker on the ORIGINAL side that it was on before.
17) Snap the carrier plate back into place.
18) You're done PICS TO FOLLOW