Motorola Motoactv :: Biking - Reported Distance Is Wrong?
Jul 8, 2012
I've had issues with the distance being way off while hiking/jogging on trails. While annoying, I decided I could live with it as I really liked the MotoActv as a bike computer.Today, it let me down on the bike. It under reported the distance by almost 3 miles. Looking through the CVS file, I am not sure why this occured. It doesn't look like the GPS dropped out during the ride. The battery in my speed/candance sensor died 21 minutes into my 70 minute ride but I wouldn't expect this to matter for the distance. I also used my Garmin 910XT and it correctly reported the distance. It's frustrating as it has been very accurate on the bike. It had been the one reason I have kept it and not returned it.
If you see the screenshot, you will notice that the end marker is not where I finished (green flag).Does this mean it doesn't pick up the last bit of my route? Does this mean it doesn't time it correctly? Does this mean that the map is off but the time and distance are correct?
I am trying to understand how I can do an indoor activity without getting speed and distance data in the results.I have used the Motoactv primarily for outdoor training for hiking, walking, mountain biking, and inline skating. Additionally, I am using for various indoor activities including plyometrics, weightlifting, indoor cycling, and indoor inline speed skating.I have been able to understand the use of GPS for speed and distance calculations (albeit with a number of accuracy impacting calculation concerns as noted in other posts in this forum). What I do not understand is the speed and distance calculations for the indoor activities. Nor do I have any idea on how the accelerometer (or pedometer) capabilities are used in speed and distance in conjunction with GPS for outdoor activities.
Specifically, for indoor activities other than those which are directly correlated to running, walking, cycling, or an elliptical, how are the speed and distance calculated? For example, when I did an hour of weightlifting using that category, the workout results showed that I had travelled over a mile with various speeds. It seems sensible to me that only a few of the indoor workout categories make sense for speed and distance data. I would not expect yoga or weights to track distance. Additionally, in a pretty intense indoor speed skating practice yesterday, I used the Motoactv for the first time to track my HR data. It produced some speed & distance data for the times in which I was skating, but the accuracy was in no way close. I expected no speed & distance data & I would not expect accurate data for inline speed skating (although that would be awesome). how the various indoor activities use the pedometer for speed calculation? Failing that, does anyone know how to stop an indoor activity from tracking speed & distance? Or finally, do any of the indoor activities NOT generate speed & distance?
The Motoactv device has a lot of functionality over & above competitive GPS watches in it being able to intelligently use the GPS or the pedometer for distance calculation for the specific activity. Hopefully, it also has the software logic to NOT calculate speed & distance for certain activities. Recent Garmin devices allowed you to "Use Indoor" if it could not find a GPS signal which turned off all speed/distance calcs. To prevent inaccurate non-sensical data on the Moto, we need to be able to specify activities without speed/distance or be able to turn off GPS & pedometer for specific activities.
Typical cycling computers use the sensors to measure both distance and speed. When an ANT+ speed sensor is used with the MotoACTV, does it get used for distance as well, or just speed? I commute in downtown Chicago and would welcome the more accurate distance measurement in addition to the GPS route tracking.
Is there anyway to make a workout end at a distance? I set my Motoactv to 5 miles and when it tells me the workout is completed I stop it but it always shows a sixth mile.
I have scoured the forums looking for an answer to this question but have not been able to locate one. I have found now, 8 runs in that the distance the MOTOACTV is showing is worsening rather than becoming more accurate. I have seen posts from other stating that they corrected the distance after their workout but I did not see details on how to do e also read to not recalibrate. That the MOTOACTV will become more accurate with time but my experience is that it is worsening. Should I recalilbrate or just manually adjust the distance once I know how to do
1) what "stages" are and how they're used? There is nothing in the manual about them.
2) Is there no way to have the live data screen display the total time and distance since the beginning of the workout? It appears that you can only choose lap, stage, or zone time.
Very innacurate readings. See below comparing MOTOACTV with my GARMIN 705and I know the garmin distance to be correct since I know the roads pretty well, and I created the routes using google mapsI expect some type of difference between GPS devices, for example my iphone using wahoo does not always agree witht he garmin, but the difference is less than 1%... with the MOTOACTV the difference is about 10%MOTOACTV (34 mi): https://motoactv.com/workout/show?orkoutActivityId=4QaHxB2cQMeiehkKHkX0MQ%3D%3D&activity=4GARMIN (30 mi): http://connect.garmin.com/activity/167586976MOTOACTV (44mi): https://motoactv.com/workout/showworkoutActivityId=26QvMGqURk6rA1hMEb4w1w%3D%3D&activity=4GARMIN (40 mi): http://connect.garmin.com/activity/167587461MOTOACTV (48mi): https://motoactv.com/workout/showworkoutActivityId=QxSBZlK%2FTr6vP9JT%2BAaNRA%3D%3D&activity=4
On the run viewable on the link below, the workout terminated at the completion of the 'loop', whereas it should have terminated at the start point, this caused the stats to be off by at least a km. Is there a setting to prevent the motoactv from doing this? [URL]
Will the MOTOACTV Golf Edition track shot averages? It appears to only show the shot distance if I am marking shot locations, and then I don't see the information anywhere after (including on the online portal, where it isn't listed on the map with the other information like club selection, which seems odd). I would expect the device to track and store shot distances, and also calculate averages.
On a run today I went down a spiral ramp under a bridge and lost my gps signal several times. I was wearing a footpod. I noticed my pace measurement slowed down from a 6 min mile to about 18 min/mi.
1st question...since I had a paired footpod shouldn't it have taken over to make the pace measurement more accurate in situations exactly like this?
2nd question... assuming the footpod was taking over, how accurate is it since there seems to be no way to calibrate the actual footpod. Is the data from the footpod constantly being taken into account and then integrated back into my final workout stats?
I know that when you press "start" to mark your next shot the distance of the last shot flashes on the screeen.
Is there a way for me to see the distance from the last shot without locking in the position with the "start" button? This is a feature I would use all of the time with my other GPS unit to know how far away I was so I would know approximatly where to start looking for my ball if it wasn't sitting out in the open. Also very useful for letting your playing partners know how far their drives went.
When I set a target of type "distance & time" (e.g 5 km in 25 minutes), I can not see my progress against my virtual opponent, that is, I can not see how far or how fast I am doing against that target. Just appears my data, and none from the opponent. I already have the opponent screen enabled. When I compete against a previously saved workout, it works fine.
can I see my progress against the opponent when I set a "distance & time" target, or it only works when I compete against previously saved workouts?
I had a great workout this morning, but when I was done, the calorie count was at 111. I worked out for 50 minutes and was expecting this to be at least 600.
When I uploaded the data, the calorie count stopped at about 10 minutes into the workout and the distance also stopped incrementing. I had heart rate information, but it was much lower than what I expected (I was working out much harder than the heart rate information shows.).
The image shows the results of the data. what could have caused this malfunction of the device?
Why does one need to input a tire size for cycling if the GPS should track speed and distance? I owned a Garmin 205 and did not have a sensor. I only used the GPS and was able to track speed and distance very accurately. I tested the MOTOACTV in a car for 3.5 miles. For some reason the GPS was not tracking any information except the track, which was correct. Instead of 3.5 miles, it showed 0.51 miles. Will this also happen on the bike?
Was recently on vacation and somehow while in my luggage the date got changed to 08/02/2018 on my motoactv.
I ran for 10k on the 11th of July. Noticed the date and Reset the time and date to correct date and time. Synced my work outs from the last few days okay when I got back. Only problem is when I go to recent workouts on Motoactv the recent work out is blank - "No Raw Data", on the android app I can see the run as my most recent, shows the date and data but still for 2018. there is no way on the motoactv.com site to change the date of the run.
If I do another run it still shows the run 08/02/2018 as my most recent on both the android app and on the motoactv site.
Can someone change the date to 11/07/2012 or will I have to try and delete it from the android app and lose my run data?
I just shared my latest workout to facebook. When it generates the link, the information that it puts in the little description is NOT the metrics of my run. For example, I uploaded a 4.25 mile run......when it posted to facebook, it says I had a workout of 2.32 km. Now, if someone clicks on the link, they will see the correct data, but still this bothers me.
I go to use the phone for a call and I see two reported red bar errors at the top line: No Sim Card and no Bars. I reboot to clear it; however, this is a repeating situation. I get no warning of when it "drops". The last time was on the charger, overnight.I will be taking to the Verizon store but wonder if anyone knows of this and how to fix. I am at the latest version of software.
I've owned the MotoActv for two month, I got the mysterious "moisture issues" that everyone seems to be getting even though I've never used it in the rain. But the thing that is driving me nuts is the music. When I hit random shuffle of all my songs, I hear songs I don't want to hear... song that I do not own on my computer. Where are these songs coming from? Today I heard "Boot Scoot Boogie!" I abhore country music as does my wife. Doing a computer wide search shows no evidence that the song exists on my computer. Yet there it is playing in mile four. Other mystery songs have showed up too. The performance music playlist seems to be filled with songs I never heard of, yet evidently I perform well to them.
I keep trying to sync my callender through the blackberry desktop to outlook callender, its gives me the same message all the time. Unknown error reported.Spent hrs in phone shop today with v helpfull chap, my curve will sync with his laptop, his OS is windows 7 mine is Vista.