I plugged in my iphone 4s to a receiver using a usb cord to play music and after 5-10 seconds of playing, the music stopped and the phone screen went to the welcome settings/start up settings. Is there something I can do to restore the phone and not lose data since my last sync?
Info:
iPhone 4S, iOS 5.1.1
if i erase all contact and settings it will be ok the pone again? do i need wifi for that?
Info:
iPhone 5, iOS 7.1.1
I cannot access my camera from the initial screen. Instead my screen jumps up slightly and then returns to the original position.
Info:
iPhone 4S, iOS 5.1
I recently downloaded and installed the new iOS 5.1 onto my iPhone 3GS. However, I can't actually gain access to my phone at all because the phone won't let me activate during the initial set up. My phone also keeps telling me that I have no service in the upper left hand corner when I always seemed to on the previous iOS I had (note: I have not played around with the sim at all).
Info:
iPhone 3GS, iOS 5.1
When logging to iTunes to download updates I am presented with an appleid that is not correct. If I cancel after trying to use the incorrect Id the login screen finally displays the correct appleid. How can I get the correct applied to appear on the initial login screen?
Info:
iPhone 4S, iOS 5.1
I recently downloaded BBM updated version and rebooted the phone, which rendered the phone completely useless. It does not boot up, just gets stuck at the Blackberry first loading page with the status bar showing 100%.
View 1 Replies View RelatedThe phone is new, is there a initial or how many hours need to charge for the brand new galaxy s6?
View 1 Replies View RelatedMy W385 went through a rough patch. Anyway, I flashed the firmware to it (it was displaying "init usb_bootloader" prior to the flash). Now it displays "needs initial programming" after it boots. My local Verizon "Store" said it could not be restored.
View 3 Replies View RelatedI'm trying to start the configuration in the Email Settings clicking the icon on Configuration but nothing happen.
View 4 Replies View RelatedI have an older Curve, and recently changed my gmail password. For the first time I can remember, the phone needs me to enter the Key Store password. (T-Mobile has a security certificate with some issue, and I need to tell the phone, "Trust Certificate".)
I don't think I've ever dealt with Key Store password before. My PIN doesn't work. I have never enabled the phone's Password, never set the password.
Searches here in support plus reading the User's manual for this model 8320 tells me lots of info about the Key Store - including, I might have to reset the phone (and lose lots of data) - however no where have I determined, how was this password initially set? When I reset the phone, how do I even find out what the new password is? Is this something RIM sets, or T-Mobile sets, or do I set it? (Yes I see that I can change it - but only if I know what the existing password is.)
I purchased a Playbook a week ago, have tried three times to do the initial download which I guess has to happen before you can do anything else with it. I was following instructions correctly to the best of my knowledge but everytime it says "download failed." I am very concerned that I register my new Playbook in time to get the warranty. I use a local ISP, DSL connection.
View 3 Replies View RelatedI've just got an E7 and started to set it up. When the option to transfer the address book from another Nokia phone was chosen, the phone simply died. It doesn't turn on anymore, the light does not appear when the charging cable in plugged in, and, well, it's overall not responsive.
View 3 Replies View RelatedHow to care for a new battery of x2-01? how many hours are the initial charging required?
View 8 Replies View RelatedI bought an E6-00 just one and a half month ago. Although its operating system kept restarting itself since the first time I bought, I did not care much about that as the phone was running ok after restarting itself. However, it finally gave a disk error yesterday and stuck in its main desktop screen. Then I turned the device off and when I turned it on again, it is stuck in the initial white screen where a Nokia logo was supposed to appear. Nothing happens then; the white screen persists until the battery is empty.
View 2 Replies View RelatedI recently got a Blackberry Bold 9900 and went to "create account" but made a typo in the initial account email setup. (I entered in "jamed" instead of "james" to have it sync with my email. I cannot see any way to fix this (I'm very new to blackberry)
View 1 Replies View RelatedIt now gets stuck on the initial logo page where the lg logo shows.
What i want to do now is get a backup of my files but when i connect the usb cable it only recognizes it as a recharging thing.
I have a stock Xoom wifi and have had it since day 1. Until the 3.2 a couple months back it worked fine... well as good as the subpar tegra2 will allow it anyway. Since the update I get regular wifi dropouts. Sometimes it happens when using the browser. I'll get a pop up that says it can't connect to the server or something like that. It isn't a regular interval. It will go 5 minutes, 30 minutes, 2 minutes, whatever. But I'm used to seeing it.
It is really evident when I try to play media via dlna from my linux server. Whether it's a HD or SD file media will stop playing using any media player (Dice, rockplayer) or any dlna client software (Upnp, BubbleUpnp, Twonky). Sometimes it happens after 30 seconds, sometimes after 5-10 seconds, other times right away. But it never makes it past a few minutes.
My router is a linksys wrt610n running dd-wrt and using both 5ghz (channel 48, n-only) and 2.4ghz bands with WPA2-AES. I've run enough test to prove it isn't the router. For my latest test I started playing an episode of the muppets show ( ) on the xoom connected on the 5ghz channel and my droid X on the 2.4 ghz channel. The xoom drops out of playing after a minutes, my X keeps playing. I switch the xoom to 2.4ghz and play the episode again. The xoom drops out again after 30 seconds. X is still going. I go upstairs and work out while watching the rest of the episode fine on my X.
While I'm streaming media I watched bandwidth monitors on the router. The droid X looks very stable with the connection rate around the same Mbps as the video file. The xoom looks like a slasher movie. It spikes to a real high rate (20mbps-ish) 2-4 times the file's rate, then it drops to about 0. It quickly spikes to about double the file's bit rate and then drops back to just above 0 again. It keeps this up until it finally just stops.
I did a device reset on saturday and all it did was annoy me as I had to re-setup everything again. The straw that finally got me was I need the device to develop an app that uses my LAN constantly and I can't since the connection isn't stable.
To summarize. Every wifi device on my network works fine (laptop, 2 droid X phones, and a printer) and my Xoom worked fine right up until I received the 3.2 update. Now it barely works.
I've read the initial charge just needs make the charging indicator turn green as the current is switched off by the phone then. Part way through the first charge I identically turned it on, I shut it down straight away, will this cause a problem with the battery capacity? I've read it should be a constant charge or are battries these days much more robust?
View 2 Replies View RelatedCan I change any of the four app launch options on the initial unlock screen? I rarely use the camera, but there is another app I would like to be able to open quickly.
View 1 Replies View RelatedI was on Verizon with a Droid 2 when you did the 2.3.3 test a couple of weeks ago. On 10/9/2011 I moved to Sprint and bought a Photon 4G. I just updated my HEX MEID in this forum profile. My phone did the initial reboot but came back with Update Failed.Update Motorola Software says. An Update is currently being downloaded. You will be notified when the download is complete. There is no indication anything is happening. It's been this way for close to an hour now.
View 15 Replies View RelatedHave a Nexus 5 running the latest lollipop build that has been working properly for a while (Phone is a Google refurb from November 2014, replacing my original N5 that had battery issues; Warranty expired Feb 2015)4 days ago, it randomly rebooted and then got stuck on the "Optimizing apps" page on initial bootup - would never go past a certain app number.First tried wiping cache - which didn't complete even after 48 hours.
Next tried full wipe from recovery, which worked but then shutdowns still happened.Reflashed all stock images (Phone is stock, not rooted) last night - problem still exists with random shutdown - but I can always get past initial setup; shutdown problems happen a little while later during use.Wiping cache from recovery now gives a "Could not mount /cache/" error in recovery
that there's sector(s) on the eMMC that's borked. It's a 32GB phone - is there a way I can flag off a certain sector as "bad" and put the cache partition somewhere else? Also, replacing the eMMC chip if needed (I can find someone set up for BGA work). I considered doing a file check from Philz / TWRP, but since the issue persists after a full reflash/reformat I assume that it's not a software bug.
I tap "ok" and the message comes back again. The strange thing is that the message is in spanish (I have my phone in English and that the lockscreen photo has dissapeared and the xperia theme is there now.
It seems like the phone is working ok in the background, but I cannot access the homescreen.
I can take screenshots, change the volume, etc. and as I could access the phone's internal and sdcard I made all the backups as possible.
Can we have a feature to start a pre-selected playlist when a run or what ever is started, its a right pain to have to go and start the playlist then start the run, wait for GPS etc etc.
View 3 Replies View RelatedI update my iphone 4 to ios 5.1.1 ,after update ios i am unable to find APN settings for EDGE/GPRS settings?
Info:
iPhone 4
I have an LG dare that will not start. It charges but wont start, is there any program that I can use to start it up from within the program? it seems that my buttons wont respond, but if I could use some kind of program to start it up, I want to start it up and use bitpim to get my contacts.
View 1 Replies View RelatedWhile browsing I have stumbled on two sets of settings, that i can't find any more:
1. battery saving settings...not just "make sure to turn off unused apps". I mean "go to menu options and select..." .
2. internet browsing settings...similar to above, but geared toward browser settings.
In the "message settings' option menu, "e-mail settings" isn't available. I have managed to set up several email accounts by simply going into the 'email" option in the "messaging" menu, but I can't set the phone to check for emails automatically or to notify me of new emails, etc, etc, in other words, I have no menu option, for adjusting the settings for emails. I am running the latest version of the software
version 10.60.
There is no "Voicemail settings" in the "Call settings" section. It seems like a first page of Call settings is missing because at the top of the list it says "Call settings", then immediately under that it says "Other call settings".
View 5 Replies View RelatedMy iPhone 4 was working fine, but then 10 minutes later it wouldn't turn on and will not power up even when plugged in. I have all the most recent updates, this phone was never jailbroken. No matter what I try to do, my phone won't react.It's as if it's bricked nut I have no idea why.
Info:
iPhone 4, iOS 5
My iphone 4s turns off itself. And I can not turn it on anymore. It is no use to connect to the charger.
Info:iPhone 4S, iOS 5.1
My iphone 3gs is off and wont start up. And when plugg it into the charger it starts up for a minute and shut down. but whithout charger dosnt do anything. Cant restore and it is not a battery problem.
Info:
iPhone 3GS, iOS 5.0.1
